Slide hammer puller set

This very handy set is ideal for those close-quarter, inside pulling jobs. Very practical for pulling motor, generator, and magneto bearings. Also good for removing small-bore bushings, bearings, and oil seals.

Slide hammer puller set 

This useful set contains a reversible-jaw slide hammer puller with a 2.5 lb. sliding hammer plus an assortment of special jaws (3 of each size) and adapters. In this set, you get all the versatility you demand of a slide hammer puller.

Sliding hammers only –

Bearing cup remover

The 7136 is perfect for pulling internal bearing cups, seals, bushings, etc. Jaw spread – 23,8 to 82,6 mm, reach to 88,9 mm. Use with any slide hammer having 5/8″-18 thread (Power Team 1155, 1156 or 927 Push-Puller®).

Pilot bearing pullers

These very versatile pullers are built especially for inside pulling jobs, and particularly for removing flywheel pilot bearings on machines and construction vehicles. Also very practical for pulling motor, generator and magneto bearings.

Special slide hammer puller

Ideal for pulling jobs in very close quarters, as in removal of small-bore bushings, bearings, oil seals, etc. Internal pulling attachment has jaw spread of 12,7 to 35 mm. Handle end has a 1/2″– 20 thread.

Basic slide hammer units 

Compatible with internal pulling attachment. Compatible with female-threaded adapters, and male-threaded adapters. 610 mm in length, 5/8″–18 threaded end.

Reversible-jaw slide hammer pullers 

Ideal for pulling gears, bearings, outer races, grease retainers, oil seals, etc. Two or three jaws may be used and positioned for “inside” or “outside” pulling jobs. Both have 5/8″– 18 threaded end so attachments and adapters may be used.

Slide hammer pullers with cup pulling attachments

These combine a basic slide hammer with Number 1152 internal pulling attachment for removing oil seals, outer races, and bearing cups from blind holes.